exit fullscreen mode visual studio code linux

The terminal process terminated with exit code: 33. NOTE: Any generated log error messages will be displayed.įATAL ERROR: command exited with status 33: nrfjprog -program /mnt/hdd/Users/javie/Documents/Programming/nRF/dk1/build/zephyr/zephyr.hex -sectoranduicrerase -f NRF52 -snr 683834403 NOTE: For additional output, try running again with logging enabled (-log). If error conditionĮRROR: persists, run the same command again with argument -log, contact NordicĮRROR: Semiconductor and provide the generated log.log file to them. runners.nrfjprog: Flashing file: /mnt/hdd/Users/javie/Documents/Programming/nRF/dk1/build/zephyr/zephyr.hexĮRROR: JLinkARM DLL reported an error. West flash -d /mnt/hdd/Users/javie/Documents/Programming/nRF/dk1/build -skip-rebuild -runner nrfjprog -snr 683834403 > Executing task: nRF Connect: Flash dk1/build (active) < In VSC I am able to build one of the sample projects, however I get this error when trying to flash it to the board:

I also ran the nrfjprog -i command, and the ID of the device shows up (683834403), which also appears under Connected Devices, in the nRF Connect for VS Code.

When running lsusb command in a terminal, I am also able to see the SEGGER J-Link device on the list of bus devices. Instead, I need to leave it halfway through between the VDD and USB positions for LED5 to turn on (I noticed that LED1-4 also turn on very slightly).Īt this point however, I am able to see the board connected on my computer, showing up on my file manager as JLINK. I've made sure to connect the USB cable on the right port (I have also used this same cable to program some other boards and it works fine), turned on the power switch (SW8), however the Power Source switch (SW9) seems to be faulty, since I set it to the VDD (center) position and the board does not turn on. I went through the Getting Started section from the user guide, but I am also experiencing some hardware inconsistencies. I recently got a nRF52840 DK and have set up nRF Connect + Visual Studio Code (running on Linux/Ubuntu based system).

Exit fullscreen mode visual studio code linux